Editable Garland Retro (255808)

Editable Garland Retro 3d model
Plinth E14, length 10-30m, pitch 14-27cm.
ATTENTION: In case of incorrect docking of all cartridges with the wire, correct the initial direction of the spline horizontally through the main (yellow) vertex.
It is important that in the spline (in the wire) sharp corners should be from two vertices, otherwise some of the lamps will look up or to the sides.
The garland was created with Corona Scatter, the composition is edited
through a spline (wire). The number of lamps automatically changes depending on
wire lengths with the same pitch.
The Spacing value sets the pitch at your discretion.
The scene should be in mm.
max 2013 corona
obj without interactivity
mtl